- 9
- 656 997
LioliosBikes
Приєднався 17 лют 2011
Fox Float Air Chamber Service
Fox Float Series
Air Sleeve Maintenance
How to replace the air chamber seals on (almost) all Fox float shocks.
Music: Hot Mess by Audionautix is licensed under a Creative Commons Attribution license (creativecommons.org/licenses/...)
Artist: audionautix.com/
Air Sleeve Maintenance
How to replace the air chamber seals on (almost) all Fox float shocks.
Music: Hot Mess by Audionautix is licensed under a Creative Commons Attribution license (creativecommons.org/licenses/...)
Artist: audionautix.com/
Переглядів: 75 687
Відео
Fox Float air chamber service - trailer
Переглядів 4358 років тому
COMING SOON... Fox Float series air sleeve maintenance Music: Hot Mess by Audionautix is licensed under a Creative Commons Attribution license (creativecommons.org/licenses/by/4.0/) Artist: audionautix.com/
NN Restoring
Переглядів 1,9 тис.12 років тому
Old ten speed bike restoring and singlespeed conversion Ανακατασκευή ενος παλιού "αγωνιστικού" ποδηλάτου και μετατροπή σε singlespeed
Rock Shox Tora 140mm travel increase
Переглядів 56 тис.12 років тому
Increasing the travel on a Rock Shox Tora 302 fork from 100mm to 140mm
Shop demo
Переглядів 57812 років тому
Help us caption and translate this video on Amara.org: www.amara.org/en/v/B7Wx/
1st Downhill Race Seli 2011
Переглядів 1,9 тис.12 років тому
1st Downhill Race at Seli, Greece 28 Aug 2011
Shop Demo
Переглядів 25513 років тому
Help us caption and translate this video on Amara.org: www.amara.org/en/v/B7Wv/ Help us caption & translate this video! amara.org/v/B7Wv/
Cuánto aceite lleva el dampet?
What is the service kit world number for this fork???
This video was literally pointless . What kit did you use. What oil did you use.how much oil did you use. What about the other side. Did you use silicone greade on the threads or something else ? Wtf dude .I hate dumb videos .more information the better .things you think are unnecessary others cherish .try harder next time please
Great job
Great !! I have a question... Where did you find the service kit...? Thank you !
Que musica horrivel nao consigo prestar atencao.
Чаво? Он просто болты открутил, выбил направляющие, вытянул ноги из штанов до 145 мм и типо он ход увеличил так 😂 ипать магия! Я так и 200 мм хода могу зделать! а шо бы работало не?
Uh. What oil did you put in there ? And how much of it ?
oil chart .. depending on the fork really...
Great video, I got a rebound knob stuck after removing and installing the damper. Didn't take damper apart yet, just did a cleaning and oil change. What could be possible route cause ?
Nice video but its so sad becsuse you dont say nothing about what kind of oíl and grease you are using .
I spin my rebound knob but it's soft and doesn't do anything. could it mean i have no fluid or broken seals?
bought a used gary fisher for cheap and has good parts for my marlin 6.
@@borderex9993 Did you figure it out? I've got a 2011 F29 on a trek that I have to service
@@imafeltersnatch7634 no, i'm just riding like that
And how much oil is in the tube? Thnks
Hello thanks for the video, a question. How much oil and what type is inside the locking mechanism? It would be great if you put descriptions and quantities to your video Thanks
I can't find that bolt extractor. Can you let me know what it's called? Thanks
www.google.com/search?q=bolt+extractor
Take the music off and explain what you're doing and why !.
Thank you for making this video! My shock feels like new again!
What is the use of the blue lever
buonasera è possibile sapere il quantitativo di olio che serve in una forcella FOX32 nella cartuccia idraulica (forcella del 2013) grazie fabio
Dude, not sure I like the way you are using a metal pick to remove the quad rings and backup rings, if you use a plastic one you wont damage any sealing surfaces ! Good luck !
can I send in my Fox Float L for rebuild. I bought a kit but dont think I want to tackle this. !lioloisbikes in san diego
Tengo una horquilla igual y le quería hacer mantenimiento. Pero en mi ciudad no existe aceite fox. Que densidad de aceite utilizas????
Buenas bro, en la página de Fox, dice que lleva aceite de 7w. Yo tengo la misma horquilla y dentro de poco le haré mantenimiento, pero yo voy a utilizar aceite de 5w para que sea mejor la sensibilidad. Ahí estás tú cuál prefieres ponerle. Saludos
How much oil did you re-fill on the damper side - how did you measure it out?
Happy to see you, useful.
dont understand any thing. please explain in english.
Hey there, could you put a link of the Service Kit in here? I want to ride my brothers old Mountain Bike, which hasnt been moved for the last 3 years. The damper is a fox 32 f100 and looses some oil on the tubes after sagging in. Thanks :)
any fox 32 mm rebuild kit, go on amazon
Words instead of music would be helpful.
How can I tell if it needa a service? I just bought a bike that came with this
I have a 2003 Fox Float RL (says Triad), and has 3 pos settings. None of the positions do anything, and there is not a lot of damping going on... so I'm sure doing this rebuild will resolve. Safe to say that when I do the seals that the 3 settings, assuming cleaning out that mechanism is effective, should bring back those features?
Havw you done it yet? Im in the same boat idk if my shocks even broken
@@rajgill7576 I have not yet, but keep threatening to. It's a nice bike, not at all modern compared to the bikes of this gen, but always liked it. i want to fix it... I guess I'll bite the bullet and buy the kit. Sure looks easy enough.
@@halredlus4614 nice nice. Yea I just bought a 2009? Cannondale scalpel. Freshly servi ed carbon lefty but I think my rear is bad. Im way new to bikes ahaha
What type of grease are you using to lubricate the rings? Another great video, sir! Thank you for sharing!
The Float Fluid is used for lubricating the O-rings during assembly, no grease. Float Fluid is actually a thick oil that lubricates the air chamber seals and improves sealing. A 5cc pack is included in the service kit.
So, the damper service is essentially just replacing some O-rings? Also, what type of grease were you using to lubricate the Damper Cartridge prior to the reinsertion into the fork legs? How about a video for Air Spring maintenance? Very good video for showing the steps involved! Probably the best one I've seen on YT. Thank you for sharing this!
Does the fluid have to be the official Fox Float fluid or will other fork /shock fluids work also? I have some Motorex Racing fork oil . It says 5w race quality. Do you think that will work? Thanks
Float Fluid is very thick, for lubricating and preventing air leaks. 5W fork oil is too thin for the task. Many people use 80-90W synthetic gear oil instead of Fox Float Fluid, which also works well.
Thanks for your help. I really appreciate it 🙂
Are there other things that can stop working in a 10 year old shock? I have replaced the O-rings and fluid but there is still no damping or control of the recoil. The bike bounces back up like it simply has a spring and not a shock.
@@DanoSlingz Yes, unfortunately, there are also other things that can go bad... Damping is not controlled by the air chamber (this is only the spring) but by the oil flow through the piston valves in the oil-filled cylinder at the lower part of the shock body. This oil is much thinner (5-10wt) than the Float fluid. If there is no damping at all, then either there is a damage at the piston or the valve shims, or there is not enough oil. If you noticed (relative) lots of thinner oil in the air can, then probably oil is leaking from the shock shaft seal (the one in the center of the air piston). The total quantity of damping oil is actually very little, so a small leak can make a big difference. In any case, it is very difficult to go deeper in the shock without specific knowledge and tools because of the internal high pressure (250 to 300+ psi) nitrogen charge. The shock has to be serviced by a Fox service center, or a suspension specialist.
@@LioliosBikes, thank you for the information. Sounds like the 10 year old shock needs to be replaced. I have a backup bike but gotta get my GT going again. ❤️ my GT!!
My rebound adjuster came out and I got it back in. The rebound settings seem to be stuck though. Any advice?
The rebound adjuster can't come out just by turming. Probably, something is broken and the adjusting needle cannot be turned, or , if oil came out too, there is not enough oil in the damping circuit. In any case, the shock has to be serviced by a Fox service center, or a suspension specialist, because of the internal high pressure (250 to 300+ psi) nitrogen charge requiring special equipment.
@@LioliosBikes Thank you. Got hold of the right people to sort it out. I like being able to fix things myself, cant this time. lol
Gee J just do it yourself
Fox float de 140 de 32 me podrías decir la cantidad de aceite que lleva en cada lado de las barras gracias un saludo
Thanks for posting this video, it doesn't need any narration or insane dance music, very clear and should save me about £60
Fucking stupid music.. .
Bom dia, you poderia fazer a manutenção de um Shox vivid Air R2C 2012, pois o meu está com defeito e eu não sei consertar. Thanks
Bang on that video is Lad thanks very much,😁
De la fábrica a tu casa
Great video, i managed to rebuild a f80 RL with that video. Thanks you saved me a lot of money. To all the haters down in the comment section: there's no comment on the video needed all you need is to observe the service once otherwise there's something wrong with you.
Excelent video
Very nice and informative - thanx!
thanks for the detailed commentary on what you're doing and why you need to do it!! great!! top work!!
Thanks for taking the time to put this video together. It helped me out a lot.
Can i do this on tora 2014 year???? Pleass help me
MUITO BOM IRMAO VALEW FICA COM DEUS
as well as the disperse it to 140mm?
What kind of grease for screws have you used?
great video!!!
I hit the mute button and it was smooth sailing from there!
just did mine following your action. thx a lot. just got to see on riding now!